The Amen break ring

A set of silver stacking rings featuring the famous "Amen break"


More on the Amen break here. Of course it's relatively simple to apply this technique to any other sound sample. Maybe the Apache break, or Funky Drummer. Or even something which isn't a breakbeat. 

Comments

  1. Unknown1 June 2018 at 08:19

    hi.. very nice blog..
    if interested in Sterling Jewelry then do visit our websit. you can also find a wide range of innovative and unique gift products which can make your occasion special.

    ReplyDelete

Post a Comment

Popular posts from this blog

EverBrite ProtectaClear Metal Finishing Coat - Test and Review

Image
I recently acquired a small bottle of EverBrite's ProtectaClear coating, a skin-safe, one part coating for metal jewellery. Supposed to be tough, hardwearing and so on, to keep metals safe from tarnish and oxidation and other damage. It's simple enough to use - a light, clear liquid which brushes on easily and dries fast - but does it work? Time to run some tests. I prepared a few bits of copper, as that tarnishes quickly and I have scraps kicking around my workshop. Also a chance to try out my new letter punches. Nice and clean, not 100% polished by hey - just a test, right? Fully degreased and prepped for coating. Coated and dry and ready to go. The zero band has no coating, the one a single coat, the two a double coat. Time to put these things through some punishment.   OK, top to bottom: A - On my keyring. Two days of being bashed around in my pocket with assorted bits of metal in close contact. B - Tied to my shoe. An afternoon
Read more

Resin-inlaid Wood

Image
A non-jewellery post, for a change. We were running a bit short on shelving in the kitchen and wanted somewhere we could store all the preserves we're going to make from the garden this year, so we went to the timber yard to see what they had. They had this, 155cm long piece of chestnut. It was pretty heavily cracked and pitted, with knotholes and so on. But, I had a plan. Resin inlay. A technique traditionally used with a colour-matched epoxy to the wood, to give an "invisible" repair. I'm taking a slightly different approach. First job, seal off the holes from the bottom, using aluminium plumber's tape. It's super sticky so it seals well, and it won't be damaged by the resin either. You might need these seals to hold for a few days, depending on the weather. Make sure the wood is level, otherwise you'll end up with wonky resin bits. Now it's time to mix the resin. Give it a good mixing and then add your pigment. If you warm i
Read more